Mitutoyo 511-522 ABSOLUTE Digimatic Bore Gauge, Range 4.0 - 6.5" (101.6 - 165.1 mm)
This ABSOLUTE Digimatic bore gauge is specifically intended for measuring inside diameters.
• Up to four extension rods (250 mm or 500 mm) can be used for measuring at the bottom of a hole 2 m deep. The display and grip may be rotated to a maximum of 320 degrees. Moreover, the display can be tilted up to 90 degrees, allowing It may be read readily from any angle. • The minimum value holding function provides easy measurement of hole diameter. The diameter of a hole can be easily measured. Washers that can be swapped out are included as standard. Accessories that allow for small-step setting Interchangeable washers are supplied as standard accessories to enable setting in small steps. Setting the bore gauge to a master value using a gauge block set allows quick and accurate setting.
